TPM Wash Solvent, 5 l

TPM Wash Solvent from 3D-basics is a low-odour and highly effective solvent with a purity of ¡Ý 99%, which is used to dissolve uncured resin on SLA printed parts. The TPM (Tripropylene Glycol Monomethyl Ether) is non-flammable, has a lower evaporation rate than, for example, isopropanol (IPA) and can also dissolve much more resin (up to 4 times) than other conventional solvents on the market.

The solvent is compatible with Formlabs. Thanks to the fact that there are no special requirements for storing this product, it can be used in offices, laboratories and other interiors without any problems.

Tip: 3D-basics canister keys are suitable for opening the canister. These protect your hands from cracks and irritation. You should wear nitrile gloves when handling the agent!

Caution: The TPM is compatible with Formlabs Wash and Formlabs Wash L. It is not compatible with Formlabs Biocompatible Resin and Formlabs Polyurethane Resin.

Note: Both the TPM and the container should be disposed of at a designated location in accordance with local regulations.

Manufacturer's recommendation for use:

1. Fill the cleaning container with TPM Wash Solvent.
2. Before submerging the SLA printed parts in the solvent, it's a good idea to pre-clean them in a separate container with TPMs from previous cleaning cycles. This allows you to extend the life of the fresh solvent.
3. Place the printed parts in the TPM and clean them for at least 5 minutes.
4. Now wash the TPM-cleaned parts with water or isopropanol.
5. Dry the parts and check if a sticky surface is left. If this is the case, you can repeat the process.
6. If after a repeated cleaning cycle the surface of the parts is still sticky, it is recommended to replace the TPM with a fresh one.